System call

The accessorious remote control unit is equipped with “system call” function allowing a series of remote control signals to be transmitted by pressing a single button.

This function can be used for example to turn on the amplifier’s power, select the input source, turn on the monitor TV’s power, turn on the source component’s power and set the source to the play mode, all at a signal button.

(1)System call buttons

Up to 10 signals each can be stored at the “CALL1” and “CALL2” buttons.

(2) Storing system call signals

1

Press the power ON/SOURCE button and the OFF button at

 

 

the same time.

 

• “PRE” appears on the remote control unit’s display.

2

Use the • and ª cursor buttons to display “CALL” on the

 

 

remote control unit, then press the ENTER button.

 

• Display “SEL” on the remote control unit’s display.

3

Use the • and ª cursor buttons to display the name of the

 

 

device you want to register at the system call button, then

 

press the ENTER button.

 

• Display “KEY” on the remote control unit’s display.

1

1

DVD

1

5

2, 3

7

2, 3

 

The display switches as shown below each time the •and

ªcursor buttons are pressed.

AMPCD CDRMDTAPEZONE2DVD

TVCABLEDBS VCR2VCR1 VDP

It is also possible to select the mode directly using the mode buttons.

4

Press the button you want to register. “SET” is displayed and

 

 

the button is registered.

 

• Once the button is registered, the “KEY” indicator

 

reappears and the next button can be registered.

 

 

5

The mode can be switched by pressing a mode button while

 

 

the “KEY” indicator is lit.

 

Press the ENTER button to turn the “KEY” indicator back on,

 

setting the registration standby mode.

6 Repeat steps 4 and 5 to register the desired buttons.

7

Press the “CAL1” or “CAL2” button while the “KEY”

 

 

indicator is lit to register the signals at the system call button.

 

• “OK” is displayed and the set returns to the normal

 

operating mode.

40