Recalling preset stations

•Recalling preset stations from the remote control unit.

1

Watching the display, press the

 

 

SHIFT button to select the preset

 

memory block.

2

(Remote control unit)

Watching the display, press the

 

 

CHANNEL + (UP) or – (DOWN)

 

button to select the desired preset

 

channel.

(Remote control unit)

•Recalling preset stations from the main unit‘s panel.

1

1

2

 

Press the TUNING PRESET button.

 

2

(Main unit)

 

Turn the FUNCTION knob and

 

 

FUNCTION

 

 

select the desired preset channel.

 

(Main unit)

1

2

13LAST FUNCTION MEMORY

•This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off.

This function eliminates the need to perform complicated resettings when the power is switched on.

•The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage from when the main unit’s power switch is off and with the power cord disconnected.

14INITIALIZATION OF THE MICROPROCESSOR

When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the microprocessor is required by the following procedure.

1

Switch off the unit and remove the AC cord from the wall

outlet.

 

 

2

Hold the following PURE DIRECT button and ZONE 2 button,

and plug the AC cord into the wall outlet.

3

Check that the entire display is flashing with an interval of

about 1 second, and release your fingers from the 2 buttons

and the microprocessor will be initialized.

 

 

 

1 2

NOTES:

•If step 3 does not work, start over from step 1.

•If the microprocessor has been reset, all the settings are reset to the default values (the values set upon shipment from the factory).

70