7

8

Select “Yes”.

a.If the “Auto” mode is selected:

Test tones are automatically emitted from the different speakers.

The test tones are emitted from the different speakers in the following order, at 4-second intervals the first time and second time around, 2-second intervals the third time around and on:

1spkr

SB

FL C FR SR SBR SBL SL SW Flashing

2spkrs

When the surround back speaker setting is set to “1spkr” for “Speaker Configuration”, this is set to “SB”.

Use the CURSOR up and down buttons to adjust all the speakers to the same volume.

The volume can be adjusted between –12 dB and +12 dB in units of 1 dB.

b.When the “Manual” mode is selected

Use the CURSOR left and right to select the

Example: When the volume is set to –12 dB while the test tone is being produced from the subwoofer

speaker for which you want to output test tones, then use the CURSOR up and down to adjust so that the volume of the test tones from the various speakers is the same.

Flashing

Example: When the volume is set to –12 dB while the subwoofer is selected

9

After the above settings are completed, press the ENTER button again.

 

 

The “Channel Level” screen reappears.

To cancel the settings, select “Level Clear” and “Yes” on the “Channel Level” screen, then make the settings again.

The level of each channel should be adjusted to 75 dB (C-weighted, slow meter mode) on a sound level meter at the listening position.

If a sound level meter is not available adjust the channels by ear so the sound levels are the same. Because adjusting the subwoofer level test tone by ear is difficult, use a well known music selection and adjust for natural balance.

NOTE: When adjusting the level of an active subwoofer system, you may also need to adjust the subwoofer’s own volume control.

When you adjust the channel levels while in the SYSTEM SETUP CHANNEL LEVEL mode, the channel level adjustments made will affect ALL surround modes. Consider this mode a Master Channel Level adjustment mode.

After you have completed the SYSTEM SETUP CHANNEL LEVEL adjustments, you can then activate the individual surround modes and adjust channel levels that will be remembered for each of those modes. Then, whenever you activate a particular surround sound mode, your preferred channel level adjustments for just that mode will be recalled. Check the instructions for adjusting channel levels within each surround mode on Page 56.

You can adjust the channel levels for each of the following surround modes: PURE DIRECT/DIRECT, STEREO, 5CH/7CH STEREO, DOLBY/DTS SURROUND, HOME THX CINEMA, WIDE SCREEN, SUPER STADIUM, ROCK ARENA, JAZZ CLUB, CLASSIC CONCERT, MONO MOVIE, and MATRIX.

When using either surround speakers A or B, or when using surround speakers A and B at the same time, be sure to adjust the balance of playback levels between each channel for the various selections of “A or B” and “A and B”.

24