STATUS
(Main unit)
DIMMER
(Main unit)

[2] Listening over headphones

Plug the headphones’ plug into the jack.

Connect the headphones to the PHONES jack.

The pre-out output (including the speaker output) is automatically turned off when headphones are connected.

NOTE:

To prevent hearing loss, do not raise the volume level excessively when using headphones.

[3]Turning the sound off temporarily (muting)

1

1

Use this to turn off the audio output

 

temporarily.

 

Press the MUTE button.

 

 

Cancelling MUTING mode.

 

 

Press the MUTE button again.

(Remote control unit)

[4] Combining the currently playing sound with the desired image

1

Simulcast playback

1 Use this switch to monitor a video source other than the audio source.

Press the VIDEO SELECT button until the desired image appears.

VIDEO

SELECT

Display

IN=V SOURCE

(Main unit)

Cancelling simulcast playback.

•Select “SOURCE” using the video select button.

•Switch the program source to the component connected to the video input.

[5] Checking the currently playing program source, etc.

1 -q1-e1-w

q On screen display

1

• Each time an operation is performed,

 

 

a description of that operation

 

 

 

 

 

 

appears on the display connected to

 

 

 

 

 

 

the unit’s VIDEO MONITOR OUT

 

 

 

jack. Also, the unit’s operating status

(Remote control unit)

 

can be checked during playback by

 

 

 

 

pressing the remote control unit’s ON

 

 

 

SCREEN/DISPLAY button.

 

 

 

Such information as the position of the input selector

 

and the surround parameter settings is output in

 

sequence.

 

 

wFront panel display

• Descriptions of the unit’s operations are also displayed on the front panel display. In addition, the display can be switched to check the unit’s operating status while playing a source by pressing the STATUS button.

e Using the dimmer function

•Use this to change the brightness of the display.

The display brightness changes in four steps (bright, medium, dim and

off) by pressing the DIMMER button repeatedly.

The brightness changes in 3 steps each time the button is pressed, and finally the display turns off.

[6]Switching the surround speakers

1

1

The surround speakers switch as

shown below each time the SPEAKER

 

button is pressed.

SURROUND A

SURROUND B

 

SURROUND A+B

(Remote control unit)

 

This operation is possible when the setting for using both surround speakers A and B is made at “Speaker Configuration” in the System Setup Menu.

51