Recalling preset stations

•Recalling preset stations from the remote control unit.

1

Watching the display, press the

 

 

SHIFT button to select the preset

 

memory block.

 

(Remote control unit)

1

2

(Remote control unit)

Watching the display, press the CHANNEL + (up) or – (down) button to select the desired preset channel.

2

•Recalling preset stations from the main unit‘s panel.

1

Press the TUNING PRESET button.

 

TUNING

 

PRESET

(Main unit)

2

Turn the SELECT knob and select

 

SELECT

 

the desired preset channel.

(Main unit)

2 1

13LAST FUNCTION MEMORY

•This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off.

This function eliminates the need to perform complicated resettings when the power is switched on.

•The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage when the main unit’s power switch is off and with the power cord disconnected.

14INITIALIZATION OF THE MICROPROCESSOR

When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the microprocessor is required by the following procedure.

1

Switch off the unit and remove the AC cord from the wall

 

 

outlet.

 

 

2

Press and hold the DIRECT buttons and STEREO buttons, and

 

 

at the same time, plug in the AC cord.

 

 

3

Check that the entire display is flashing with an interval of

 

 

about 1 second, and release your fingers from the 2 buttons

 

 

 

and the microprocessor will be initialized.

 

 

NOTES:

1

2

•If step 3 does not work, start over from step 1.

•If the microprocessor has been reset, all the button settings are reset to the default values (the values set upon shipment from the factory).

75