NOTE:
•If you exceed the number of signals that can be registered, “FULL” appears on the remote control unit’s display and only the number of signals that can be registered are registered (up to 10 operations).
(3) Using the system call function
1 | Press the button at which the system call signals have been stored. |
| |
| • The stored signals are transmitted successively. |
|
|
(1)Punch through button
Buttons used in the CD, CDR, MD, TAPE, DVD, VDP, VCR1 and VCR2 modes can be assigned to the buttons shown on the diagram at the right which are not normally used in the AMP, TV, DBS and CABLE modes.
For example, when the CD mode is set to the punch through mode in the AMP mode, the CD mode’s PLAY, STOP, MANUAL SEARCH, AUTO SEARCH, PAUSE and DISC SKIP buttons’ signals are sent in the AMP mode.
(2)Making the punch through setting
1 | Press the power ON/SOURCE button and the OFF button at |
| |
| the same time. |
| • “PRE” appears on the remote control unit’s display. |
2 | Use the • and ª cursor buttons to display “PUNCH” on the |
| |
| remote control unit, then press the ENTER button. |
| • “SEL” appears on the remote control unit’s display. |
1 | DVD | 1 |
(1) 
2, 3, 4
2, 3, 4
3 | Use the •and ªcursor buttons to display the mode for which | 4 | Use the •and ªcursor buttons to display the mode you want | |
you want to make the punch through setting, then press the | ||||
to punch through, then press the ENTER button. | ||||
ENTER button. | ||||
| • “SEL” appears on the remote control unit’s display. |
| • “OK” is displayed and the punch through is set. | |
|
|
|
The display switches as shown below each time the •and
ªcursor buttons are pressed.
The display switches as shown below each time the •and
ªcursor buttons are pressed.
AMP |
| DBS |
| CABLE |
| TV |
| CD |
| CDR |
| MD |
| TAPE |
|
|
|
|
|
|
| ||||||||
|
|
|
VCR2
VCR1
VDP 
DVD
It is also possible to select the mode directly using the mode buttons.
It is also possible to select the mode directly using the mode buttons.
40