The accessorious remote control unit is equipped with “system call” function allowing a series of remote control signals to be transmitted by pressing a single button.
This function can be used for example to turn on the receiver’s power, select the input source, turn on the monitor TV’s power, turn on the source component’s power and set the source to the play mode, all at a signal button.
(1)System call buttons
Up to 10 signals each can be stored at the “CALL1” and “CALL2” buttons.
(2) Storing system call signals
1 | Press the power ON/SOURCE button and the OFF button at |
| |
| the same time. |
| • “PRE” appears on the remote control unit’s display. |
2 | Use the • and ª cursor buttons to display “CALL” on the |
| |
| remote control unit, then press the ENTER button. |
| • Display “SEL” on the remote control unit’s display. |
3 | Use the • and ª cursor buttons to display the name of the |
| |
| device you want to register at the system call button, then |
| press the ENTER button. |
| • Display “KEY” on the remote control unit’s display. |
(1) 
1 | DVD | 1 |
5
2, 3
7 | 2, 3, 5 |
|
The display switches as shown below each time the •and
ªcursor buttons are pressed.
| AMP |
|
| MULTI |
|
| CD |
|
| CDR |
|
| MD |
| TAPE |
|
| DVD | |||||||||
|
|
|
|
|
|
| |||||||||||||||||||||
|
| TV |
| CABLE |
| DBS |
|
| VCR2 |
|
| VCR1 |
|
| VDP | ||||||||||||
|
|
|
|
|
|
|
| ||||||||||||||||||||
| It is also possible to select the mode directly using the | ||||||||||||||||||||||||||
| mode buttons. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||||||
4 | Press the button you want to register. “SET” is displayed and |
| |
| the button is registered. |
| • Once the button is registered, the “KEY” indicator |
| reappears and the next button can be registered. |
|
|
5 | The mode can be switched by pressing a mode button while | |
the “KEY” indicator is lit. | ||
| ||
| Press the ENTER button to turn the “KEY” indicator back on, | |
| setting the registration standby mode. |
6 | Repeat steps 4 and 5 to register the desired buttons. | |
|
| |
|
| When settings are stored at all 10 keys, “FULL” is displayed |
|
| and no more settings can be stored. |
|
|
|
7 | Press the “CALL1” or “CALL2” button | |
|
| |
|
| while the “KEY” or “FULL” indicator is lit |
|
| to register the signals at the system call |
|
| button. |
•“OK” is displayed and the set returns to the normal operating mode.
39