Denon AVR-5700 manual After starting playback, Adjusting the sound quality tone

(Main unit) (Remote control unit)

PANEL

DISPLAY

After starting playback

[1] Adjusting the sound quality (tone)

The tone control function will not work in the direct or Home THX Cinema mode.

1	Adjust the bass sound to the desired level using the BASS
	adjustment control, the treble sound using the TREBLE
	adjustment control.
	BASS	TREBLE

• To increase the bass or treble: Turn the control clockwise. (The bass or treble sound can be increased to up to +12 dB in steps of 2 dB.)

• To decrease the bass or treble: Turn the control clockwise. (The bass or treble sound can be decreased to up to –12 dB in steps of 2 dB.)

If you do not want the bass and treble

2	to be adjusted, turn on the tone defeat	TONE
		DEFEAT

mode.

2 The signals do not pass through the bass and treble adjustment circuits, providing higher quality sound.

[2] Listening over headphones

Plug the headphones’ plug into the jack.

2Connect the headphones to the PHONES jack.

The pre-out output (including the speaker output) is automatically turned off when headphones are connected.

NOTE:

To prevent hearing loss, do not raise the volume level excessively when using headphones.

2 1

Lightly press on the bottom of the door to open it.

[3] Turning the sound off temporarily (muting)

1	Use this to turn off the audio output
	MUTING
	temporarily.

Press the MUTING button.

2Cancelling MUTING mode. Press the MUTING button again.

[4]Combining the currently playing sound with the desired image

Simulcast playback

1	Use this switch to monitor a video	VIDEO
		SELECT

source other than the audio source. Press the VIDEO SELECT button repeatedly until the desired source appears on the display.

2Cancelling simulcast playback.

•Select “SOURCE” using the video select button.

•Switch the program source to the component connected to the video input.

[5]Checking the currently playing program source, etc.

	DOLBY / DTS
HOME THX CINEMA	SURROUND	DIRECT
DSP SIMULATION	5CH STEREO	STEREO
		MASTER VOL.
INPUT MODE	ANALOG	EXT.IN

AUDIO		DECK	MD		1
		CD	LOCK	MUTING
AVR/AVC	VIDEO	DVD	TV
		VDP	VCR

1

1	On screen display
	•	Each time an operation is performed, a
		description of that operation appears
		on the display connected to the unit’s
		VIDEO MONITOR OUT jack. Also, the
		unit’s operating status can be checked
		during playback by pressing the remote
		control unit’s ON SCREEN button.
		Such information as the position of the
		input selector and the surround
		parameter settings is output in
		sequence.
	Front panel display
	•	Descriptions of the unit’s
		operations	are		also	PANEL
		displayed	on	the	front
		panel display. In addition,
		the display		can	be
		switched to check the
		unit’s operating status
		while playing a source by
		pressing	the	PANEL
		button.

ON SCREEN

RETURN

	SYSTEM	SURROUND
TUNING	SETUP	PARAMETER
BAND	TITLE	MENU/GUIDE
		CH SELECT
MODE		ENTER
		SELECT	1
MEMORY	PANEL	ON SCREEN
	DISPLAY	RETURN
USE/LEARN T.TONE	MULTI	DVD	1
		SET UP

1

Using the dimmer function

• Use this to change the brightness of the display. DIMMER The display brightness changes in four steps

(bright, medium, dim and off) by pressing the remote control unit’s DIMMER button repeatedly.

2The brightness changes in 3 steps each time the button is pressed, and finally the display turns off.

39