CONTENTS
ENGLISH
3CONNECTING THE INCLUDED ANTENNAS
zMain Features ………………………………………5
xBefore Using ………………………………………5
cConnecting the Included Antennas ………………5
vConnections …………………………………………6
bPart Names, Functions and Displays …………7, 8
•Receiver …………………………………………7
•CD Player ………………………………………8
nRemote Control Unit …………………………9, 10
mListening to Radio Programs ……………………11
, Using the Timer ……………………………12 ~ 14
.Playing CDs ………………………………………15
•About Compact Discs …………………………15
•Normal Playback …………………………15, 16
•Various Playback Functions ……………16 ~ 18
⁄0Other Information …………………………………19
⁄1Specifications ……………………………………19
⁄2Troubleshooting …………………………………20
DENON Service Network…………………………53, 54
Installing the FM indoor antenna
Tune in an FM station (Refer to page 11.), set the antenna in a position in which distortion and noise is minimum, then fasten the tip of the antenna in this position using tape or a pin.
FM antenna
Installing the AM loop antenna
Tune in an AM station (Refer to page 11.) and set the antenna in a position as far from the system as possible in which distortion and noise is minimum. In some cases it is best to invert the polarities.
AM broadcasts cannot be received well if the loop antenna is not connected or if it is set close to metal objects.
Assembling the AM loop antenna
Check that the following parts are included in the package aside from the main unit:
• | • |
• Remote control unit | • System connector cable …………………………1 |
• R6P/AA batteries …………………………………2 | • RCA |
• Operating instructions ……………………………1 |
|
• FM antenna ………………………………………1 |
|
• AM loop antenna …………………………………1 |
|
1 MAIN FEATURES
• Quality power for high quality sound | • Two types of timers |
30 W + 30 W (4 Ω /ohms, DIN) high quality | Two timer settings can be made – everyday and |
AM loop antenna
FM COAX 75º |
| LOOP AM |
|
| ANT. |
Assemble the included AM loop antenna as shown in the diagram.
qRemove the clamp.
wInsert the AM loop antenna into the antenna stand.
Antenna stand
amplifier and terminals for large speakers. | sleep. |
• High sound quality, | • |
Connecting an FM outdoor antenna
Connecting the AM loop antenna
Connect the included AM loop antenna to the antenna terminals as shown in the diagram.
2BEFORE USING
Read the following before using the system.
•Before turning on the power
Check again that all connections are correct and that there are no problems with the connection cords. Be sure to unplug the power cord before connecting or disconnecting the connection cords.
•Humming may be produced if this system is set near a TV or other audio equipment.
If this happens, try changing the position of the equipment or the connection cords.
•Moving the system
Be sure to remove CDs before moving the system. If a CD is left in the CD player, it may be scratched. To prevent
•Condensation (dew)
Condensation (water droplets) may be produced on internal optical lenses or discs in the following cases:
•Directly after a heater is turned on.
•When the system is in a steamy or humid room.
•When the system is moved abruptly from a cold place (room) to a warm room.
•Should condensation occur:
The signals on the disc cannot be read and the system will not function properly. Remove the disc then let the system set with the power on. The condensation will evaporate in one hour or less, at which time the system will function normally.
•Note that some of the illustrations used for explanations in this manual may differ from the actual system.
If good reception cannot be achieved with the included FM antenna, use an FM outdoor antenna. Connect an
Ω/ohms) terminal.
Selecting a place for the FM outdoor antenna
•Set the antenna so that it is pointing towards the broadcast station’s transmitting antenna. Behind buildings or mountains, set the antenna in the position at which reception is best, and also try changing the direction of the antenna.
•Do not install the antenna under power lines. Doing so is extremely dangerous, as the power line could touch the antenna.
•Install the antenna away from roads or train tracks to avoid noise from cars or trains.
•Do not install the antenna too high, as it may be hit by lightning.
q Loosen the | w Insert the | e Tighten the |
terminal | antenna | terminal |
knobs. | wire. | knobs. |
Installing an AM outdoor antenna
Connect the signal wire from the AM outdoor antenna to the antenna terminal. Be sure to ground the antenna and connect the ground wire to the GND terminal. Also be sure to connect the included AM loop antenna.
5