Desa 107624-01 Operating Chain Saw, Turn thumbscrew clockwise to tension saw chain, English

SAW CHAIN TENSION ADJUSTMENT

Continued

❸b	Models 107625-01,
	107625-02, and
	111174-01
	TI
	G
	H
	T
	E
	N

Turn thumbscrew clockwise to

tension saw chain...

❹	Approx.
	Guide Bar

1/8"

Pullchaintochecktension.Guidelinks should not come out of guide bar groove...

❺

OPERATING CHAIN SAW

WARNING: Read and understand this ownerÕsmanualbeforeoperatingthissaw. Make certain you read and understand all Important Safety Information, pages 3 through 5. Improper use of this chain saw can cause severe injury or death from Þre, electricalshock,orbodycontactwithmov- ing chain, or falling wood.

FILLING OIL TANK

1.Remove oil cap.

2.Fill oil tank with SAE #30 motor oil. Note: For temperatures below 30¡F, use SAE #10 oil. For temperatures above 75¡F, use SAE #40 oil.

3.Replace oil cap at once. Tighten oil cap Þrmly for good seal. This will avoid oil seepage from tank.

4.Wipe off excess oil.

Note: It is normal for oil to seep when saw is not in use. Empty oil tank after each use to prevent seepage.

OILING CHAIN

Manual Oil System

Always check oil level before using saw. Do not at- tempt to operate the oil system while saw is in op- eration. To oil chain, press squeeze bulb. Oil will feed onto the guide bar and chain. Press squeeze bulb at least once before each cut. Check oil level often by looking at oil sight window (see Figure 7).

Automatic Oil System

Chain saw Model 107625-01, -02, 111174-01 is equipped with an automatic oiling system. It will pro- vide adequate lubrication to the guide bar and saw chain. Check oil level every 15 minutes of cutting time. Oil level can be seen in oil sight window (see Figure 8, page 10).

Oil Squeeze Bulb

ENGLISH

IG
T	H
	T		Oil Sight Window
	N
	E	I
		T G
			H
			T
			E
			N

Figure 7 - Oil Squeeze Bulb and Oil Sight Window

Location for Model 107624-01, -02

Make sure chain moves freely around
guide bar then tighten both nuts.		Continued
107705	11	www.desatech.com

107705-01 11 12/16/03, 4:07 PM