Desa V)CD36RN, (V)CD36RPE Operating Fireplace, Millivolt For your safety Read before lighting

Fireplace

Installation

Continued

WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.

4.Open the bag of ember materials.

5.Break apart about quarter sized pieces and place about a single layer along the full length of the ember tray to hide the bottom edge of the base log. (see Figure 59).

6.Replace the glass door and louver panels. See

Removing/Replacing Glass Door, page 29.

Ember

Material

Ember

Tray

Figure 59 - Applying Ember Material

Operating Fireplace

Millivolt

for your safety

Read before lighting

WARNING: If you do not fol- low these instructions exactly,

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it, call a qualified service technician.

Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

lighting

instructions

1.STOP! Read the safety information above.

2.Open lower louver panel.

3.Turn off all electric power to the fire- place.

4.Push in gas control knob slightly and turn clockwise to “OFF” (see Figure 60).

5.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor.

If you smell gas, STOP! Follow “B” in the safety information above. If you don’t smell gas go to the next step.

6.The pilot is located by the main burner and should not require accessing for lighting.

7.Turn gas control knob counterclockwise to “PILOT”.

a fire or explosion may result causing property damage, per- sonal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

Gas Control Variable
Knob	Control Knob
	OT
	IL
	P
	IL
P OT
F	HI
F	O
O
	N
	LO
IN	OUT

Piezo Ignitor

TPTH TP TH

Figure 60 - Control Valve

116035-01E www.desatech.com 31