Desa (V)CD36RPE, (V)CD36TP Local Codes, Product Features, Pre-Installation Preparation

Local Codes

Install and use fireplace with care. Follow all local codes. In the absence to local codes, use the cur- rent National Fuel Gas Code ANSI Z223.1/NFPA 54* (USA) or the current CSA-B149.1 Installation Code (Canada).

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

Product Features

These are a few facts that can help you understand and enjoy your direct-vent fireplace:

•The CD36R dedicated rear vent is best suited for flush or corner installations when vented horizontally through an exterior wall.

•The CD36T dedicated top vent is suited for any application where height is necessary to terminate the venting system either through the roof (vertical) or to gain sufficient height and offset to vent to an outside/exterior wall (horizontal).

•The vent pipe installation is very important to allow for proper operation. You must select the appropriate unit for your application and follow the venting instructions to plan your installation.

•This fireplace may be installed in any room of your house provided all local codes and these installation instructions are followed.

•Models (V)CD36R/T are equipped with a mil- livolt gas control system that does not require electricity to operate.Apiezo ignitor is provided to light the pilot without using matches or lighters.

•Models (V)CD36RE/TE are equipped with an electronic ignition system that requires 120VAC to operate. An electrode ignitor automati- cally lights the pilot flame when the fireplace is turned on.

•All models can accept an optional circulating air blower when 120 VAC connection is sup- plied. If you plan to install an optional blower, do not forget to wire the fireplace outlet when framing.

•Each time you turn on your fireplace, you may notice some amount of condensation on the in- side of the fireplace glass. This is normal and will disappear after 10-20 minutes of operation.

•Your direct-vent gas fireplace system (fireplace and venting) is a balanced and sealed gas oper- ating unit. It is highly efficient because it uses outside air for combustion while independently heating the indoor air.

Pre-Installation

Preparation

Location and space requirements

Determine the safest and most efficient location for your DESA direct-vent fireplace. Make sure that rafters and wall studs are not in the way of the venting system. Choose a location where the heat output is not affected by drafts, air conditioning ducts, windows or doors. Figure 2 shows some common locations. Be aware of all restrictions and precautions before deciding the exact location for your fireplace and termination cap.

When deciding the location of your fireplace, follow these rules:

•Do not connect this fireplace venting to a chim- ney flue serving a separate solid-fuel burning fireplace or appliance.

•Due to high temperatures, do not locate this fireplace in high traffic areas, windy or drafty areas or near furniture or draperies.

•Proper clearances must be maintained.

•If your fireplace is to be installed directly on carpeting, vinyl tile or any combustible material other than wood, it must be installed on a metal or wood panel extending the full width and depth of the fireplace. See Figure 3, page 6.

•Your fireplace is designed to be used in zero clear- ance installations. Wall or framing material can be placed directly against any exterior surface on the back, sides or top of your fireplace, except where standoff spacers are integrally attached. If standoff spacers are attached to your fireplace, these spac- ers can be placed directly against wall or framing material. See framing details on page 7.

Flush with	Corner
a wall	installation

Through exterior wall enclosed in a chase

Figure 2 - Common Fireplace Locations

116035-01Ewww.desatech.com