![](/images/new-backgrounds/1199808/19980841x1.webp)
Fireplace
Installation
ELECTRICAL SUPPLY CONNECTION
CAUTION: Disconnect the electrical power to the supply circuit before attempting to con- nect or service this appliance.
WARNING: This appliance, when installed must be electri- cally grounded in accordance with local code or in the ab- sence of local code, with the current National Electric Code, ANSI/NFPA 70, or the Canadian Electric Code, CSA C22.1.
A
Note: If you do not need to relocate the junction box, to connect the electric supply follow steps 8 through 11 only:
1.Remove 2 screws and outer cover with strain relief bushing on right side of cabinet (see Figure 34).
2.Remove inner retaining screw on junction box mounting tab.
3.Slide junction box up until screw mounting tab is lined up to notch in outer cabinet.
with Strain | Cover |
Relilef | |
| |
| Strain Relief |
4.Swing the junction box out and slip retaining flange out through the slot in outer cabinet.
5.Remove two screws and outer cover on the left side of the outer cabinet.
6.Reinsert junction box retaining flange through slot now on the left side and swing screw mounting tab back through notch as before.
7.Slide the junction box down till mounting tab holes line up and replace the inner retaining screw.
8.With junction box cover removed, pull the end of
9.Strip back the outer Romex to about 4" and connect black, white and green wires accord- ingly using 3 wire nut connectors.
10.Tuck tailing wires into junction box and replace junction box cover using 2 remaining screws.
11.Tighten down strain adjustment on universal bushing until Romex sheathing is secured.
The electrical connection is now complete.
Installing optional blower accessories
NOTICE: If installing blower in an existing fireplace with gas connections, shut off gas sup- ply and disconnect heater from gas supply. Contact a qualified service person to do this.
WARNING: If there is a du- plex electrical outlet installed in the right side of the bottom of the fireplace base area, be sure that the electrical power to the outlet is turned off before proceeding with blower instal- lation. Failure to do this may result in serious injury.
Romex Cable
Receptacle
Screw/Tab
Retainer
Model BK Installation
Follow all instructions provided in the blower accessory kit.
1. Attach power cord to blower motor by firmly |
pushing the two female terminals at the end of |
Figure 34 - Relocating Junction Box
Receptacle and Electrical Supply
Connection
power cord onto the two spade terminals on |
blower motor (see Figure 35, page 22). |
www.desatech.com | 21 |