EN
operation
OPERATION
Startup
To begin operation, verify that your IntelliPAP is connected to a ‘live’ power source. When plugged in, the LCD display should appear as noted.
Off
Put on your CPAP mask and press the ON/OFF button on the keypad to turn on airflow OR put on your CPAP mask and take a few breaths to turn on airflow automatically. The pressure in your mask will rise to the set pressure in about 10 seconds.
The keypad display shows the actual mask pressure while the device is in use. Because this is the actual pressure, the device pressure reading may vary slightly as you breathe. Your display should appear as noted.
P:10.0Auto
If your DeVilbiss IntelliPAP system includes a humidifier, its heater controls and status are displayed as noted in the image.
P:10.0Auto
Heat:Off
Using The Comfort Delay Feature
Your IntelliPAP has a comfort delay feature to help make it easier for you to fall asleep. The airflow will start at a low pressure and then gradually
You can adjust the amount of time spent in comfort delay by using the advanced device controls. The Delay Time can be adjusted from 0 to 45 minutes in
Delay Running 10 Minutes Left
Comfort delay is available in both IntelliPAP Standard and IntelliPAP AutoAdjust models, and in all modes of operation.
Comfort Delay Feature In Standard CPAP Mode
When you use the comfort delay feature while your device is operating in CPAP mode, the airflow you receive at the beginning of your therapy is temporarily lowered to a pressure selected by your physician when the device was setup.