Diamondback 1190 Sr manual Workout Programs

1190SROM 9/22/06 1:51 PM Page 27

Workout Programs, continued

•Or press “ENTER” key to enter program setup mode. The message display will bring you through the program setup step by step as below:

Entering Age

1.If ENTER key is pressed, the message window will flash once, “ENTER YOUR AGE”, then “AGE = XX” will start blinking.

2.Press “UP/DOWN” key to adjust the age.

3.After age is adjusted, then press “ENTER” key to accept.

Entering Weight

1.If ENTER key is pressed, the message window will flash once, “ENTER YOUR WEIGHT”, then “WEIGHT = XX” will start blinking.

2.Press “UP/DOWN” key to adjust the weight.

3.After weight is adjusted, then press “ENTER” key to accept.

Entering Program Time

1.If ENTER key is pressed, the message window will flash once, “ENTER PROGRAM TIME”, then “TIME = 30 MIN” will start blinking.

2.Pressing “UP/DOWN” key to adjust the time. When the time setting reaches 60 minutes, the display will show “TIME = 1HR 00MIN”.

3.After time is adjusted, the message window will display “SET UP COMPLETED” “PRESS START TO BEGIN”. You may press the “START” key to begin this program.

Note: You may press the START key at any time during program setup to skip the adjustment and begin your workout. By doing so, the console will use default value of age andweight for %HR and calories burned calculations.

During the Program

Display

•Once the program is started, the message window will display the workout data of “Time, Intensity Level, Watts, and Calories”.

•If no pulse is detected, the Pulse display will show “- - -” until there is a pulse, and the HR bar graph will not be illuminated.

•If a pulse is detected, the Pulse display will display the BPM, and the HR bar graph will illuminate to indicate your %Max. HR.

Adjusting Intensity Level

•Press the “UP/DOWN” key to adjust the intensity level to L1 and up to L20 during anytime of the program.

•Each time the “UP/DOWN” key is pressed it will adjust the intensity level of the remaining portion of the program.

Pause, Reset, Switch, Stop or Save the program

See Basic Operation section for details.

Ending the Program

•When the selected program time is up or the “STOP” key is pressed, there will be a beep to signify the end of the program and Cool Down will become active

•The message window will scroll the messages “THE PROGRAM ENDED” then “3:00 COOL DOWN BEGIN”

•The “Start” key can be pressed to re-start the program.

1190 Sr Owner’s Manual 25