INSTALLING AND POINTING YOUR SATELLITE DISH ANTENNA
CAUTION
Local electric codes and the National Electric Code (NEC) require the satellite dish antenna to be grounded. Grounding the satellite dish antenna helps protect against damage caused by static voltage buildup or nearby lightning strikes.
Refer to the following:
∙Go to the section titled “Grounding the Metal Pole Mount” if your satellite dish antenna is installed on a metal pole.
∙Go to the section titled “Grounding the Base Plate” if you satellite dish antenna is installed on the supplied satellite dish antenna mast.
Grounding the Metal Pole Mount
Have the following tools and materials handy during this process. Items marked with a asterisk
(*) indicate that they are included in the
∙
∙
∙#8 aluminum grounding wire *
∙Cable ties *
∙Adjustable wrench
∙Sledge hammer
Installation Procedure
1)Approximately 1 foot from the pole’s cement pier foundation, use a sledge hammer to drive the ground rod 8 feet into the ground.
2) Install the grounding clamp approximately 1 foot from the base of the pole.
3) Install the #8 aluminum grounding wire onto the ground clamp in accordance with National Electric Code
4)Route the ground wire from the clamp to the ground rod. Use the ground rod clamp to attach the grounding wire to the ground rod.
5)Secure the ground wire to the pole using the cable ties.
You can now proceed to the section titled “Installing and Routing the LNB Coaxial Cable.”
Grounding the Base Plate
Have the following tools and materials handy during this process. Items marked with a asterisk
(*) indicate that they are included in the
∙ | ∙ | Adjustable wrench | ∙ | Sledge hammer | |
| ground rod | ∙ | #8 aluminum | ∙ | Cable ties * |
|
| ||||
∙ | ground rod clamp |
| grounding wire * |
|
|
PAGE
