DirecTV HIRD-D11, HIRD-D01 Using the Remote Control, Identifying Codes that Have Been Stored

PROGRAMMING YOUR REMOTE CONTROL

VCR	CODE NUMBER	VCR	CODE NUMBER	VCR	CODE NUMBER
	159	Soundesign	034	Totevision	040 101
Sansui	043 048 135 022	STS	013	Unitech	040
Sanyo	003 010 102 007 014 134	Sylvania	031 059 034 067	Vector	012
				Research
Scott	017 037 044 129 131 112	Symphonic	034
	159	Tandy	010 034	Video Concepts	012 046 034 141
Sears	003 008 009 010 013 014	Tatung	039 043 023	Videosonic	040
	017 081 101	Teac	034 039 043 023	Wards	003 013 024 031 034 040
Sharp	031 054 053	Technics	031 070		053 054 017 131
Shintom	024			Yamaha	012 043 034 039
		Teknika	031 019 034 101
Signature	034	TMK	006	Zenith	072 080 056 048 034 101
					058
Sony	056 057 058 003 052 149	Toshiba	112 008 131 047 059 082
	031 155		013 042

Using the Remote Control

Once your codes are entered, you are ready to start using your universal remote control. The device keys allow you to switch from one device to another. Some keys behave in a special way. They control one device while you are actually in another device mode. For instance, while in SATellite mode, pressing Volume +/- controls your TV’s volume—not a digital satellite receiver volume. This is because the remote control knows that there is no volume control on the digital satellite receiver.

Advanced feature keys (i.e. , ) are not supported for devices other than your digital

satellite receiver. For other devices, only the primary keys (i.e. and , ) will function.

∙For Sony-brand devices, use the key as the “Enter” key.

∙For RCA-brand devices, the device key (i.e., “TV” or “VCR”) might be the “power on” key and is the power off key.

Switching the Remote Control to Operate Additional Digital Satellite Receiver

Your remote control can be reprogrammed to operate additional digital satellite receivers. This may be necessary in situations where multiple digital satellite receivers are located in the same general area and can pick up signals intended for each other.

To switch the remote control, simply press and hold the key while entering the receiver ID. The receiver ID can be 001 through 004. Do not forget the two zeros. Remember to access the ADVANCED PREFERENCES screen using the keys on the front of the digital satellite receiver to pair it with the remote control.

Identifying Codes that Have Been Stored

You can determine the codes that are stored in your remote control. This may be useful for reprogramming additional remote controls later on.

1.Press the device key and the “Mute” key simultaneously.

2.Press the key and count the number of times the red light on the top of the remote control blinks. Each digit of the three-digit code is separated by a 3-second period the light is off. For example, if the code number is 021, the light will blink 10 times (for “0”), pause three seconds, blink twice, pause three seconds, and blink once.

PAGE 8-3