Off-Line, Address | Dolby Laboratories P/N 91659 specification

DolbyRemote Installation and Operation	Establishing Communication

through the front panel of the encoder. The rate you select in DolbyRemote must match the rate selected in the unit.

Address

The default address setting for the DP567 and DP569 is 0x8280. If the address has been changed from the front panel of the encoder, set the remote address accordingly. If DP561 is selected as the Device Type, only the Port parameter may be set; Baud and Address are fixed at 38,400 and 9080, respectively.

2.1.3Off-Line

The DolbyRemote application may be used off line, without the presence of an encoder. This allows configurations to be preprogrammed and stored. Off-line mode is selected by checking the Off Line box when opening a unit.

Figure 2-2Device Off Line

Once the desired parameters have been set, as described above, click OK. The DolbyRemote Window is displayed. When the DolbyRemote application establishes communication with the unit, it will display the unit's current settings.

2-2

Page 12

Image 12

Dolby Laboratories P/N 91659 manual Off-Line, Address

Contents

DolbyRemote Dolby Laboratories Inc Corporate HeadquartersEuropean Licensing Liaison Office Far East Table of Contents Opening a Device Further Information List of Figures DolbyRemote Open Device WindowPage DolbyRemote Overview DolbyLoadRequirements PC System Requirements Software Installation Encoder Firmware Cable Installation Microsoft DLL FilesPage Starting DolbyRemote Device TypeCommunications Port Off-Line Address Additional Devices 3DolbyRemote Window Removing Devices Saving and Restoring Configurations Exporting ConfigurationsOpen Configuration File Save Configuration FilePage Audio Service Parameters Input Meters Audio Coding Mode Data RateClock Source LFE Enable Bitstream ModeDialog Normalization Audio Bandwidth Encoder ControlPass Through Bypass Coding Delay Unit Name Preprocessing Input Filtering Surround Channel Processing Dynamic Range Compression Line Mode and RF Mode Bitstream InfoBitstream Information Input Level Meter Dual Mono Audio Production Information Audio Service Configuration Input Level, Line Mode and RF ModeDialog Normalization Mix Level, Room Type and Info Exists Input and Output Settings Input Output Aux DataSource Channel Assignment Multiplex Mode Input Subcode Status BitsTest Tone Generation Audio Bit Reference Input Stream NumberReference Input Input Presets Reference Input Subcode Status BitsRecall Stream Number Configure Save Current ConfigurationTime Code Parameters Number Preset Current Time CodeStart Time Code and Stop Time Code Values Status Select Stereo Music in the Preset Pending field Resume Opening a Device DP569/DP567DP561 General Further Information Am 530 p.m., Monday Friday