DolbyRemote Installation and Operation | Dolby Digital Parameters |
|
|
|
|
For instance, you might want the Stereo Music preset to take effect at time code 00:12:22:12.
To do this, you follow the following procedure:
1.Select the Time Code tab page
2.Enter 00:12:22:12 in the Start Time Code field
3.Select Stereo Music in the Preset Pending field.
When time code 00:12:22:12 occurs, the unit will switch to the Stereo Music preset. The Preset Pending field will display None and the Current Preset field will display Stereo Music.
There are a few restrictions on the recall preset on time code feature:
•Once you have selected a start time and a preset, you can’t change the start time. If you want to change the start time, you must follow this procedure:
1.Select None in the Preset Pending field.
2.Enter the new Start Time Code value.
3.Select the correct preset in the Preset Pending field.
•Pressing any of the preset buttons, immediately invoking a preset, cancels any pending preset
•If the unit is in Time Code Control mode, start and stop encoding is determined by time code, it cannot also recall a preset based on time code. In other words, the unit can either use time code to determine when to start and stop encoding, or to determine when to recall a preset, but not both.
4.8.5Resume
This button copies the Stop Time Code value to the Start Time Code value to permit seamless encoding of two sections of continuous material.
