Audio Service Configuration | Dolby Laboratories P/N 91659 instruction

DolbyRemote Installation and Operation	Dolby Digital Parameters

Figure 4-5Dual Mono Tab

4.4.1Audio Service Configuration

Dialog Normalization

Dialog Normalization sets the dialnorm value for channel two when in 1+1 Coding Mode only.

4.4.2Dynamic Range Compression

Input Level, Line Mode and RF Mode

Input Level, Line Mode and RF Mode meters for channel two when in 1+1 Coding Mode only. The Compression Characteristic is the same as that applied to channel one in the pre-processing section.

4.4.3Audio Production Information

Mix Level, Room Type and Info Exists

Mix Level, Room Type and Info Exists are informational parameters for channel two when in 1+1 Coding Mode only.

4-10

Page 26

Image 26

Dolby Laboratories P/N 91659 manual Audio Service Configuration, Dialog Normalization, Input Level, Line Mode and RF Mode

Contents

DolbyRemote European Licensing Liaison Office Dolby Laboratories IncCorporate Headquarters Far East Table of Contents Opening a Device Further Information List of Figures DolbyRemote Open Device WindowPage Requirements DolbyRemote OverviewDolbyLoad PC System Requirements Software Installation Encoder Firmware Cable Installation Microsoft DLL FilesPage Communications Starting DolbyRemoteDevice Type Port Off-Line Address Additional Devices 3DolbyRemote Window Removing Devices Open Configuration File Saving and Restoring ConfigurationsExporting Configurations Save Configuration FilePage Audio Service Parameters Input Meters Clock Source Audio Coding ModeData Rate Dialog Normalization LFE EnableBitstream Mode Pass Through Audio BandwidthEncoder Control Bypass Coding Delay Unit Name Preprocessing Input Filtering Surround Channel Processing Dynamic Range Compression Bitstream Information Line Mode and RF ModeBitstream Info Input Level Meter Dual Mono Audio Production Information Dialog Normalization Audio Service ConfigurationInput Level, Line Mode and RF Mode Mix Level, Room Type and Info Exists Input and Output Settings Input Source OutputAux Data Channel Assignment Test Tone Generation Multiplex ModeInput Subcode Status Bits Audio Bit Reference Input Reference InputStream Number Input Recall PresetsReference Input Subcode Status Bits Stream Number Time Code Parameters ConfigureSave Current Configuration Number Start Time Code and Stop Time Code Values PresetCurrent Time Code Status Select Stereo Music in the Preset Pending field Resume DP561 Opening a DeviceDP569/DP567 General Further Information Am 530 p.m., Monday Friday