Input and Output Settings | Dolby Laboratories P/N 91659 specification

DolbyRemote Installation and Operation	Dolby Digital Parameters

4.5Input and Output Settings

Figure 4-6Input/Output Tab

4.5.1Input

Lock Status

Lock Status shows whether the input channels for the current coding mode have been detected and locked by the encoder.

Sample Rate

Sample Rate shows the sample rate of the digital input channels.

Integrity

Integrity shows the data integrity of the digital input channels.

Format

Format is a control parameter that allows you to choose the format of the data received from the input source. Available Input Format selections are:

•PCM: Dolby Digital encoding will be enabled. When analog is selected as the DP567 input source, the input format must always be PCM.

•Pre-encoded: Pass-through mode will be enabled. Pre-encoded bitstreams move through the unit, unmodified, to the output.

4-11

Page 27

Image 27

Dolby Laboratories P/N 91659 manual Input and Output Settings

Contents

DolbyRemote Far East Dolby Laboratories IncCorporate Headquarters European Licensing Liaison Office Table of Contents Opening a Device Further Information DolbyRemote Open Device Window List of FiguresPage PC System Requirements DolbyRemote OverviewDolbyLoad Requirements Encoder Firmware Software Installation Microsoft DLL Files Cable InstallationPage Port Starting DolbyRemoteDevice Type Communications Address Off-Line 3DolbyRemote Window Additional Devices Removing Devices Save Configuration File Saving and Restoring ConfigurationsExporting Configurations Open Configuration FilePage Input Meters Audio Service Parameters Audio Coding Mode Data RateClock Source LFE Enable Bitstream ModeDialog Normalization Bypass Audio BandwidthEncoder Control Pass Through Unit Name Coding Delay Input Filtering Preprocessing Dynamic Range Compression Surround Channel Processing Input Level Meter Line Mode and RF ModeBitstream Info Bitstream Information Audio Production Information Dual Mono Mix Level, Room Type and Info Exists Audio Service ConfigurationInput Level, Line Mode and RF Mode Dialog Normalization Input Input and Output Settings Channel Assignment OutputAux Data Source Audio Bit Multiplex ModeInput Subcode Status Bits Test Tone Generation Input Reference InputStream Number Reference Input Stream Number PresetsReference Input Subcode Status Bits Recall Number ConfigureSave Current Configuration Time Code Parameters Status PresetCurrent Time Code Start Time Code and Stop Time Code Values Resume Select Stereo Music in the Preset Pending field General Opening a DeviceDP569/DP567 DP561 Am 530 p.m., Monday Friday Further Information