Control Inputs, Priority | Dynacord DRM 4000 specification

SOFTWARE EDITOR DRM 4000

7.4.4 Control Inputs

This offers the possibility for individually programming the parameters of the corresponding control input (contact 1 to contact 8). For details on individual parameters, please refer to chapter 8 “CONFIGURING THE DRM 4000”.

Setting each control input parameter to “No Change” is also possible. When activating a control input, all parameters that are set to “No Change” are not altered.

When the DRM 4000 is connected to your PC, using the “Online Control”-soft key allows establishing any settings in real-time.

Priority

The possibility for assigning priorities to the control input is provided here. Priority 8 represents the highest priority setting while priority 1 represents the lowest setting. The control input with the highest priority setting overrules the others whenever several control inputs are active.

The BASIC CONFIGURATION always has the lowest priority (priority 0). Therefore it is active with no control input being activated.

When assigning identical priorities to two or more control inputs, the last set overrules the others.

7-5

Image 22

Dynacord DRM 4000 owner manual Control Inputs, Priority

Contents

DRM Safety Component has to be Replaced with Original Part only For US, Canada and Japan only Contents Introduction Introduction DRM 4000 CharacteristicsCharacteristics Field of Application Unpacking and Warranty Controls and Connections Controls and Connections Tone Control LO / HI Ducking indicators a / B12, POWER-switch Control AUX 16, Control 18, Direct OUT 20, Send output 26, PAD-switch27, +24V-switch 21, MIX in input Uick Start Quick Start General Notes Installation and ConnectionsInstallation and Connections Input Assignment 1 MIC/LINE inputs Send outputs AUX and MIX in inputsOutput Assignment 4.3.1 Master outputs Direct Outputs Control Inputs Control InputsExternal VCA-Control Level Adjustment for MIC/LINE-inputs Power-On OperationLevel Settings Initial Operation Level Adjustment for AUX-inputs Using Ducking Control Special Features of the DRMSpecial Features of the DRM Limiter Operation Using The Unit Together With The DPM Software Editor DRM Installation NotesSoftware Editor DRM System Requirements Software Description 7.4.1 General Menus And The Toolbar File Menu Communication Menu Basic ConfigurationView Menu About Menu Aux-inputs Name and CommentMIC/LINE-inputs Outputs Priority Control Inputs View Status Online Control / StatusTest Configuring the DRM N Figuring the DRM Basic Configuration Internal Settings / Extensions Internal SettingsInternal Configuration Possibilities Low Cut Filter Limiter Settings AUX Sensitivity Selection HOW to Install Extensions How to install the Input Transformer NRS 90233, EDP-No How to install the Output Transformer NRS 90227, EDP-No How to install Interface-Boards Specifications SpecificationsPeci F I C a T IO N S User Configuration Specific a Tions Specifica Tions Block diagram Switching Contacts Via Software 10.4 RS-232 Interface Programmer’s Instructions Online-Access to all Parameters REMOTE/PRIO value Dimensions Warranty Garantie