The following table describes the parameters of this page:
| Field |
|
| Description |
|
|
|
| The Virtual server rule index for this VC. You can specify |
| Rule Index |
|
| 10 rules in maximum. All the VCs with single IP will use |
|
|
|
| the same Virtual Server rules. |
| Rule Type |
|
| Choose the |
|
|
| Overload, | |
|
|
|
| |
|
|
|
| Enter the local IP Address you plan to map to. Local Start |
| Local Start/End |
|
| IP is the starting local IP address and Local End IP is the |
| IP |
|
| ending local IP address. If the rule is for all local IPs, then |
|
|
|
| the Start IP is 0.0.0.0 and the End IP is 255.255.255.255. |
|
|
|
| Enter the public IP Address you want to use for NAT. |
| Public Start/End |
|
| Public Start IP is the starting public IP address and Public |
| IP |
|
| End IP is the ending public IP address. If you have a |
|
|
|
| dynamic IP, enter 0.0.0.0 as the Public Start IP. |
5.5.4.QoS
The QoS provides better service of selected network traffic over various technologies. This function can be set based on the physical LAN ports or wireless interfaces under IPv4 or IPv6 version respectively.
IP Version: IPv4
Choose Advanced Setup > QoS, the page shown in the following figure appears.
69
