Diagnostics | Edimax Technology AR-7286WNB specs

5.7.5.Diagnostics

Choose Maintenance > Diagnositics, the page shown in the following figure appears. The page shows the test results for the connectivity of the physical layer and protocol layer for both LAN and WAN sides.

The following table describes the parameters of this page:

Field	Description
Virtual Circuit	Choose a PVC from the drop down list to test.

88

Image 88

Edimax Technology AR-7286WNB user manual Diagnostics

Contents

AR-7286WnA / AR-7286WnB Copyright Contents Trouble Shooting Safety Precautions Package ContentsSystem Requirements LED Status & Button Definitions Front Panel WPS Rear Panel  DMZ Features QOS Connect the Adsl line Connect the router to your LAN network Connect the power adapter to the router Configuration Check the Adsl LED status Firewall settings PC LAN IP configurationPage Page Page Windows Windows 7, Windows Vista and Windows XPPage Page Windows Windows Vista Windows XP Page EZmax Setup Wizard Setup Wizard Please select your product Page Page Page Internet Connection Type PPPoE/PPPoA Bridge Mode Dynamic IP Address Static IP Description VPI PPoE/PPPoAVCI Bridge Mode Dynamic IP Address Static IP Firmware Upgrade AdsltyperoutervcmuxPage Status Accessing the RouterDevice Info System Log Ethernet Statistics StatisticsAdsl Statistics Quick Start Wlan StatisticsPage Auto setup by ISP list Field Description ISP Dynamic IP Address Bridge Mode Static IP Address PPPoE/PPPoA Interface Setup Internet ATM CBR, UBR, rtVBR, or nrtVBR PCR SCRMBS Select IPv4 , IPv4/IPv6 or IPv6 VC-Mux,1483 Routed IP LLCIPoA or 1483 Routed IP VC-Mux You can choose Activated or DeactivatedIPv4 Address NAT IPv6 Address Dual Stack Lite IPv4 Options You can select None , Both , in Only or OUT Only IPv6 Options Select Activated or Deactivated Recommended Connect On-Demand or Connect Manually Field Description Connection SettingYou can select None, Both, in Only or OUT Only Field Description Dual Stack Lite You can choose 1483 Bridged IP LLC or 1483 Bridged LAN Dhcp Select Enable or Disable You may choose ManagedAddr or Other ConfigPage Field Description Access Point Settings WirelessYou may choose Activated or Deactivated Multiple SSIDs Settings 802.11b+g, 802.11n, 802.11g+n or 802.11b+g+n 11n SettingsEven numbers only Advanced Setup WPS SettingsSelect from Disabled , WEP-64Bits , WEP-128Bits Wireless MAC Address Filter Firewall Routing NAT Address Mapping for Multiple IP Service DMZ Field Description QoS Choose the One-to-One , Many-to-One , Many-to-ManyOverload , Many-to-Many No Overload , or Server IP Version IPv4 Field Description Quality of Service Rule MAC Select Low , Medium , High or Highest DscpIP Version IPv6 IPv6 You may select Activated or Deactivated . Activated must Vlan Page Adsl Vlan ID ACL Access ManagementChoose Annex a , Annex I , Annex A/L , Annex M or Filter Support Web , FTP , Telnet , Snmp , Ping or AL L Filter Support IP / MAC Filter, Application Filter and URLChoose Both, Incoming or Outgoing ICQ MSNYmsg URL Filter Snmp URL UPnP Ddns Cwmp URL for the CPE to connect to the ACS using the CPE WAN Administration MaintenanceTime Zone Firmware Upgrade SysRestart Diagnostics Question Answer 255.255.255.0, respectively EU Declaration of Conformity Weee Directive & Product Disposal Declaration of Conformity