Policy Configuration
When you use QoS, you must define some policies to make some packets to have higher priority to pass through.
Figure 6-2: Policy Configuration
Data – Policy Configuration.
Network
Admission
Policy
This section identifies each policy
•Policy Name List – When adding a new Policy, ignore this list. To edit an existing entry, select it from the list, and click the "Select" button. The data fields will then be updated with data for the selected entry.
•Policy Name – Enter a suitable name. Generally, you should use the "Policy Name" for the network traffic.
•Source Address – Define the source address of packets here. It has two types like IP address or MAC address. If you select IP address, you can define IP address range, otherwise define up to four MAC addresses.
•Destination Address – Define the destination address of packets here. The explanation is as the same as above.
•Protocol Type – The field defines traffic packet type, i.e. IP,TCP and UDP.
•Source Port – Define the source port of packets here.
•Destination Port – Define the destination port of packets here.
•Priority Queue – It defines a packet if it meets all conditions defined above, it will be serviced with some priority level.
Page 51
