Troubleshooting
Troubleshooting
If you suspect a malfunction, please check your system once again, taking note of the points listed below. If it still does not function correctly, contact an Edirol Service Center or the dealer where you purchased the unit.
Operating the video fader does not switch the image
If the same image is being input to channels A and B, operating the
Operating the transformer buttons (TRANSFORMER) does not switch the image
With the factory settings, when the memory dial is set to 1, these buttons will “cut” between images. Check the position of the memory dial.
No image is output even though you play back the source device
Make sure that the output fade dial is set to the center position (green LED lit). With the factory settings, turning the dial toward the left will fade to black, and turning it toward the right will fade to white. If the dial is set all the way to left or right, no image will be output. Also make sure that the input select setting is correct.
Turning the control dial does not change the effect
Not all effects have parameters that can be modified by the control dial. If you have selected an effect whose parameter can be modified by the control dial, the channel A/B effect button will blink. If the button is only lit (not blinking), the control dial will not affect the parameter.
Image does not switch (effect not applied) in time with the BPM
Did you press the BPM sync button (BPM SYNC)? The BPM sync button (BPM SYNC) must be pressed if you want to switch the image or apply an effect in time with the BPM.
Image does not switch (effect does not apply) in time with TAP
Did you press the BPM sync button (BPM SYNC)? The BPM sync button (BPM SYNC) must be pressed if you want to use the TAP button to switch the image or apply an effect.
Operating the video fader does not switch the image in the expected direction
It is possible that if you detached the video fader to reposition it by 90 degrees, the internal connector may have been pulled out and
74
