Using your Diva 2440 Page 38
Starting the Web-based Configuration Interface
Only one user can access the web-based configuration interface at a time.

Procedure

1.
If you installed the Diva Assistant software, right-click the Diva 2440 icon in the Windows
system tray, then click ‘Properties’. Once the Diva Assistant window opens, click ‘Tools’ then
‘Configure’.
If you did not install the Diva Assistant software, start your web browser software, click ‘File’,
‘Open’, enter 192.168.1.1 and click ‘OK’. (If you changed the address of the Diva 2440, enter
the new name or address instead.)
Note: You can also use the word diva or diva.dsl instead of the 192.168.1.1 IP address
(Internet Explorer 5.0 or later required).
2.
If a password has been defined for your Diva 2440, you will see the ‘Log In’ page. Enter the
system password and click ‘Log In’.
If your Diva 2440 has no password, this page will not be shown and you will go directly to
the main menu (see next step).
Note: By default, there is no password. If you have forgotten your password, you can hold
down the reset button for 15 seconds to reset the device to factory defaults. This will erase
the existing password. However, you will also lose all customize configuration settings,
including username and password you may have entered in order to access your Internet
service.