4 SETTING UP AND CONNECTION

1

2

Setting Up

(1)Unfold the lamp arms fully until they come to the

dead end.

Unfold in the sequence specified in the drawing12 shown to the right.

3

(2)Press the column lock button, and raise the

 

column until the column lock button returns to

 

4

the original position. Make sure that the column

 

has been completely locked.

 

 

(3) Turn the camera head until the lens faces to the

5

5

 

stage.

3

 

 

 

 

4

6

(4) Plug the power cord into the power cord

 

receptacle of this product and the AC outlet.

 

 

 

7

Connection to Monitor and Projector

The following settings of this product can be switched with the DIP switch. Switch the settings

8 according to the connection environment. The factory settings are as shown in the following table:

9

10

 

 

Initial setting

Key

Function

Key selection

Content

A

To switch the resolution of images output from RGB terminals

0

SXGA

B

To switch the VIDEO output system

0

NTSC

C

To switch the screen size of VIDEO output

0

Over scan

D

To switch the electronic shutter mode

0

60

In the area where the rated supply frequency is 50Hz, when the D key is used as set at “0,” fluorescent lamps, mercury lamps and other AC lamps may suffer “flicker” due to the lighting of their discharge tubes. In this case, set the D key to “1,” and the flicker may be reduced. In the area where the rated supply frequency is 60Hz, use the D key as factory set at “0.”

11

Be sure to turn off the power supply to all equipment before making any connections to

protect this product and all the connected equipment.

When switching the DIP switch key, be sure to turn off the power supply beforehand.

When plugging/unplugging cables, be sure to do so by holding the plugs.

15

Page 16
Image 16
Elmo HV-7100SX instruction manual Setting UP and Connection, Setting Up, Connection to Monitor and Projector