REMOTE CONTROL (CONTINUED)
HOW TO USE THE REMOTE CONTROL
23feet (7m) 
30
30
1.Any object between the remote control and VCR will block the path of the beam when it is being used.
Dark walls, direct sunshine or very bright (incan- descent) light will reduce the remote sensitivity.
2.Hold the remote control within an angle range of about 30° from either side of the remote sensor as shown below.
3.When the remote control is vertical to the remote sensor, it will work within about 23 feet (7m) from the VCR.
4.Point the front of the remote control directly at the
front of the VCR.
*Function keys do not work when pressing several keys at the same time.
HOW TO INSTALL BATTERIES
1. Remove the cover on the reverse side of the remote control.
2. Install two batteries ("AAA" size) into the remote control following the polarity diagram as shown at the left.
3. Replace the battery cover.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1.Use only the size and type of batteries specified.
2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device.
3.Do not mix different types of batteries together (s. g. Alkaline and Carbon zinc) or old batteries with fresh ones.
4.If the device is not used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.
5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer's directions.)
9
