Electrical Data | Emerson Figure i instruction

Installation

2.7Electrical Data

Table 16 Electrical data—Standard sound and ambient models (95°F/35°C) 60Hz

	Nominal		Input Voltage- Phase
	Capacity	* Electrical
	Capacity	* Electrical
Model #	Tons	Characteristic	208/230-1	208/230-3	460-3	575-3

		FLA	8.4	—	—	—

14	1	WSA	10.2	—	—	—

		OPD	15	—	—	—

		FLA	12.1	—	—	—

20	1.5	WSA	14.8	—	—	—

		OPD	25	—	—	—

		FLA	13.5	—	—	—

27	2	WSA	16.5	—	—	—

		OPD	25	—	—	—

		FLA	19.3	12.8	6.4	5.9

37	3	WSA	23.8	15.7	7.8	7.1

		OPD	40	25	15	15

		FLA	—	15.3	7.1	6.6

42	3.5	WSA	—	18.8	8.7	8.0

		OPD	—	30	15	15

		FLA	—	24.1	11.7	9.1

67	5	WSA	—	29.3	14.2	11.1

		OPD	—	45	20	15

		FLA	—	35.6	17.4	13.5

96	8	WSA	—	40.8	19.9	15.4

		OPD	—	60	25	20

*FLA = Full Load Amps

WSA = Wire Size Amps (minimum supply circuit current capacity) OPD = Overcurrent Protection Device (fuse or circuit breaker)

Table 17 Electrical data—High ambient models (105°F/41°C) 60Hz

	Nominal			Input Voltage-Phase
	Capacity,	* Electrical
	Capacity,	* Electrical
Model #	Tons	Characteristic	208/230-1		208/230-3	460-3	575-3

		FLA	21.3		14.8	7.4	5.9

37	3	WSA	25.8		17.7	8.8	7.1

		OPD	40		25	15	15

		FLA	—		17.3	8.1	6.6

42	3.5	WSA	—		20.8	9.7	8.0

		OPD	—		30	15	15

		FLA	—		24.2	11.7	9.3

67	5	WSA	—		29.4	14.2	11.3

		OPD	—		50	20	15

*FLA = Full Load Amps

WSA = Wire Size Amps (minimum supply circuit current capacity) OPD = Overcurrent Protection Device (fuse or circuit breaker) Model # 14, 20 and 96 are not available in high ambient versions.

22

Image 26

Emerson Figure i manual Electrical Data, Electrical data-High ambient models 105F/41C 60Hz

Contents

Liebert Prop Fan Condensing Unit Example PFH037A-PL7 = 380/415-3ph-50Hz Table of Contents Figures Prop Fan Condensing Units Optional Equipment Equipment Inspection Location Considerations Model Numbers Dimensional Data, in. mm Lb. kg 60Hz 50Hz Dimensional DataNet Weight Cabinet and floor planning data, horizontal air discharge Footprint Dimensions Wall Mounting Piping and Electrical Connections Electrical and piping connections, horizontal air discharge 152 PFH096A- L General piping arrangement Electrical field connections, 1- to 5-ton units Top Air Discharge Models Electrical field connections, 8-ton units Single-phase, 1-3 ton model schematic, typical Three-phase, 3-5 ton model schematic, typical Three-phase, 8 ton model schematic, typical Piping Considerations Piping for Elevation Differences between PFH and Evaporator Equivalent lengths for various pipe fittings, ft m EvaporatorCondensing Unit Refrigerant charge in Liebert pre-charged R-407C line sets Pre-Charged Line SetsField-Fabricated Line Sets Line Size Length Charge R-407C Ft. m Lb-oz kg Liebert PFH unit charge levels and coupling size Recommended line sizes, OD Cu Line charges refrigerant per 100 ft m of Type L copper tube Installation of Piping to UnitsPiping connection sizes and torque Line Size OD Cu Coupling Size Torque, lb-ft. N-m Remove Existing Condensing Unit Filter Drier Selection and InstallationInstall the New Condensing Unit Evaporator Charge R-407C Indoor Unit Models Oz kg General System Charge RequirementsEvaporator Charge Levels Electrical Connections Low-Voltage Control Wire ConnectionsLow-Voltage Control Wire Sizing Electrical Data Nominal Input Voltage- Phase Capacity ElectricalNominal Input Voltage-Phase Capacity Electrical Electrical data-High ambient models 105F/41C 60Hz Electrical data-Quiet-Line models 95F/35C 60Hz Electrical data-High ambient models 105F/41C 50Hz Checklist for Completed Installation Electrical data Quiet-Line models 95F/35C 50Hz Liebert Lee-Temp Flood Back Head Pressure Control CompressorHigh Head Pressure Operation AdjustmentHot Gas Bypass Hot gas bypass diagram Electrical Failure-Burnout GeneralCompressor Failure Mechanical Failure Compressor Replacement Model Numbers 407C 60 Hz 50 Hz Oz kg Field Charge VerificationField verification charge Troubleshooting Problem Cause Remedy Uni Single-Phase&Three-Phase UPS Environmental SystemsWeb Site Monitoring Etwo