Emerson MC68HC16Z1 6.8Setup System - Setup System Info, 6.8.1Change Password, Setup System Menu

System and Control Options

6.8Setup System - Setup System Info

The Setup System Info options allow users to:

•Change Password—used for access to system setup functions

•Change Date & Time/Automatic Daylight Saving Time—used to set the Liqui-tect panel’s date and time and to enable automatic time change for Daylight Saving Time

•Restore Defaults—returns the Liqui-tect panel to its factory settings

To change any Setup System Info features:
Log In and Choose Setup System		Setup System Menu
• From the Main Menu, use the arrows ↑↓ to choose System and
			SETUP ZN1 ZONE 1
Control, then press Enter ↵ (see 6.1 - Login for help).
			SETUP ZN2 ZONE 2
• Enter your password at the Login screen.
			SETUP ALARM OUTPUTS
• From the System and Control Menu, use the arrows ↑↓	to choose		↑↓ =NEXT	↵ =SELECT
			SETUP REALARM DELAY
Setup System, then press Enter ↵ .
			SETUP MAPMODE
Select Setup System
		> SETUP SYSTEM INFO

•From the Setup System Menu, shown at right, use the arrows ↑↓ to choose Setup System Info and press Enter ↵ .

•Use the following steps to access any of the Setup System Info options.

6.8.1Change Password

A password is required to access the Liqui-tect panel’s system and control options, as described in 6.1 - Login. The password consists of four characters (see Table 7 for valid characters). The default pass- word is AAAA.

Changing the password to “0000” eliminates the login requirement and prevents the login screen from appearing.

Setup System Info Menu

SETUP SYSTEM INFO

>CHANGE PASSWORD

CHANGE DATE & TIME ↑↓ =NEXT ↵ =SELECT

FACTORY DEFAULTS

Change Password

Change the Password To change the password:

• From the Setup System Info Menu, use the arrows ↑↓ to choose Change Password, then press Enter ↵ .

•To change your password:

•Use the arrows ↑↓ to choose a character.

•Press Enter ↵ to advance to the next character position.

•When finished, press Enter ↵ again.

CHANGE PASSWORD

AAAA

↑↓ =SELECT ↵ =NEXT/END

Reset Password to the Factory Default (“AAAA”)

To reset the password to the factory default of AAAA:

•Locate DIP switch 1 on the unit’s circuit board (see 1.4 - Controller Board Overview) and move switches 2, 7 and 8 to the OFF position (down).

•Move the second switch to the ON position, then to the OFF position.

•Move the seventh switch to the ON position, then to the OFF position.

•Move the eighth switch to the ON position, then to the OFF position.

The password should now be AAAA.

35