Emerson MVME7100 manual PMC Input/Output Module, Procedure

PMC Input/Output Module Transition Module

5.6PMC Input/Output Module

If a PMC Input/output Module (PIM) has already been installed on the MVME7216E, or you are installing a transition module as it has been shipped from the factory, disregard this procedure and refer to Transition Module on page 40.

Procedure

For PIM installation, perform the following steps:

1.Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the chassis as a ground. The ESD strap must be secured to your wrist and to ground throughout the procedure.

2.Carefully remove the transition module from its packaging and lay it flat on a stable surface.

3.Remove the PIM filler from the front panel of the transition module.

4.Slide the face plate (front bezel) of the PIM module into the front panel opening from behind and place the PIM module on top of the transition module, aligned with the appropriate two PIM connectors. The two connectors on the underside of the PIM module should then connect smoothly with the corresponding connectors on the transition module (J10 and J14).

5.Insert the four short Phillips screws, provided with the PIM, through the holes on the bottom side of the transition module into the PIM front bezel and rear standoffs. Tighten the screws.

Refer to the following figure for proper screw/board alignment. The example below may not accurately represent your MVME7100.

MVME7100 Single Board Computer Installation and Use (6806800E08A) 79