INITIAL START UP GAS LINE PURGE
NOTE: UNIT MUST BE PROPERLY GROUNDED FOR ELECTRONIC IGNITION TO FUNCTION.
On initial installation, or after extended periods where the fireplace has not been used, gas lines may require purging.
The installer or qualified service person may use the following purge procedures to prevent the delays that would be caused by waiting for the lockout periods between tries for ignition.
PURGE PROCEDURE
1.Remove glass door and place away from the fireplace.
2.Turn on gas shut off valve. Follow ignition procedure.
3.If burner does not light after spark sequence has ended, use an insulated jumper wire (see page 43) between terminal locations 12 and 13 for fast reset function.
4.Interrupt power for 5 seconds. The green indicator light will blink 4 times repetitively. Then retry for ignition.
5.Allow time for any raw gas to dissipate and repeat steps 3 and 4 until ignition is achieved.
6.Turn burner off and install glass door frame assembly.
7.Test ignition of burner with glass door in place.
INSULATED
JUMPER WIRE
DIRECT IGNITION TROUBLESHOOTING
With proper installation and maintenance, your new Direct Vent Gas Fireplace will provide years of
SYMPTOM | CHECK | ACTION |
No spark when system is turned to “ON” | Check for 120V between black “hot” line | If 120V not present, check fuse or circuit |
and reset cycle* has been completed | at control module and “white” return at | breaker or repair wiring leading to |
| module | fireplace. |
Spark for six (6) seconds at ignitor, but no | a. Check that gas is turned on and system | Turn gas on and/or purge system |
ignition of burner. | purged |
|
| b. Check that tips of ignitor are directly | Position electrodes so tips are directly |
| above ports on main burner. Spark is | above burner port ports and about ¼" to |
| between electrodes and not from one | 3/8" above burner. |
| electrode to burner. |
|
| c. Check for 120V at each coil on the gas | If 120V present, but gas valve does not |
| valve and listen for click, indicating gas | click, replace gas valve. |
| valve is opening. |
|
Spark for six (6) seconds, main burner | Check for clean ground path between | Clean, position according to wiring diagram, |
lights, but goes out when spark stops. | electrode bracket and fireplace chassis. | and repair defective electric connections. If |
| Check wiring to wiring diagram label. | all electrical connections are clean and |
| Check for broken electrode on | correct, replace module. |
| lead attachment to module. |
|
Main burner lights normally and then goes | a. Check thermostat if applicable. | Turn thermostat up to call for heat or |
out. |
| replace |
| b. Check | Replace spark electrode assembly |
| for shorts. |
|
| c. Refer to installation instructions | Repair as required. |
| troubleshooting guide for issues such |
|
| as venting. |
|
Page 45 |