Command Reference Guide 11

Initialize

Initialize NETQue printer servers and NETJet printer servers installed in Hewlett-Packard printers with MIO version 6.0 or above.

>Server>> initialize [server] [delay delay_min] [cancel] [flash] [default] [disabled]

server

Reinitializes the printer server.

delay

Indicates reinitialization will not take place until

 

after a specified period of time.

delay_min

A number specifying the amount of delay in

 

minutes. The default is 1 minute.

cancel

Cancels a previously entered initialize command

 

if entered within the delay time specified in the

 

initial command.

flash

Causes printer server software to download

 

from the host to flash memory if the printer

 

server is configured for a network load.

default

Resets the printer server to factory defaults. IP

 

address and subnet mask are reset to none.

disabled

Prevents any connections after initialization. To

 

enable connections, enter the initialize

 

command through a remote console without this

 

option.

When the initialize printer server command is issued with a delay, a warning message is sent every 30 minutes to all logged in ports. Five minutes before initialization, the warning is broadcast every minute. When the printer server is reinitialized, all options modified by Set commands are reset to their permanent values, and all options modified by Change and Define commands take effect.

Below MIO Version 6.0

The initialize command will not reset NETJet printer servers in Hewlett Packard printers that do not have MIO version 6.0 or above. To reset these printer servers, recycle power on the printer.

Page 17
Image 17
Emulex Printer Server manual Initialize, Below MIO Version, Delaymin