42 Command Reference Guide
| IP address for both the load and dump |
| functions. |
ip_address | Enter the IP address of the gateway node in |
| decimal dot notation. For example, |
| 123.234.345.490. This address must be on the |
| same subnet as the printer server. |
none | Enter none to remove an existing IP address. |
| Although no IP address is chosen, the printer |
| server attempts the load or dump operation |
| without using a gateway. The printer server |
| attempts to use the IP address of the load or |
| dump host even if the host IP address is on a |
| different subnet than the printer server’s IP |
| address. |
When the printer server loads its internal software over the network, it checks to see if a gateway load_dump IP address has been set and uses the set gateway to contact the node from which it will download its operational software. In the same way, when the printer server performs a crash dump upload, it checks to see if a gateway load_dump IP address has been set and uses the set gateway to contact the node to which it will send the dump of its internal memory.
Set Dump Host
Enable or disable the printer server’s ability to send a copy of its internal memory to a specified dump host.
>Server>> [set define change] server dump [enabled disabled]
enabled | Default is enabled. When this command is |
| enabled, the printer server sends a file memory |
| image to a specified host before reinitializing |
| after a fatal error or upon execution of a Crash |
| 300 command. |
disabled | When the command is disabled, no dump can |
| occur. Prior to a dump occurring, a preferred |
| dump node must be specified. |
