| Version 1.0 |
send larger packets, the router will break them into smaller packets. Ideally, you should set this to match the MTU of the connection to your ISP. Typical values are 1500 bytes for an Ethernet connection and 1492 bytes for a PPPoE connection. If the router's MTU is set too high, packets will be fragmented downstream. If the router's MTU is set too low, the router will fragment packets unnecessarily and in extreme cases may be unable to establish some connections. In either case, network performance can suffer.
MAC Address: If you need to change the MAC address of the rounter's
Click on the Save Settings button to store these settings.
6.2.4.5 L2TP (Layer 2 Tunneling Protocol)
The WAN interface can be configured as L2TP. L2TP (Layer Two Tunneling Protocol) uses a virtual private network to connect to your ISP. This method of connection requires you to enter a user name and password (provided by your Internet Service Provider) to gain access to the Internet. The supported authentication protocols are PAP and CHAP.
Select the L2TP from the My Internet Connection
Address Mode: L2TP can be used with a dynamic or static IP address. If you select the Dynamic IP radio button, then the IIP address in the next field is not required. However, if you select the Static IP radio button, then the IP address in the next field is required.
L2TP Address: Specify the IP address
L2TP Subnet Mask: Specify the subnet mask for the IP address.
L2TP Gateway IP Address: Specify the IP address of the L2TP gateway.
45
