Enterasys Networks 2200 manual Using the Reset Button

Using the RESET Button

4.3USING THE RESET BUTTON

The RESET button shown in Figure 4-2resets and re-initializes the 2H258-17R.

CAUTION: Pressing the RESET button resets the device, and all current switching being performed by the device is halted. A network downtime of up to two minutes will result from this action.

Figure 4-2 RESET Button

															RX TX	RX TX	RX TX	RX TX
													RX TX	RX TX
			SWITCH									RX TX
											RX TX
	WORKGROUP									RX TX
FAST ETHERNET								RX TX	RX TX
							RX TX
						TX
		RX TX		RX TX	RX
	RX TX
																		16
																	15
																14
															13
													11	12
												10
											9
									7	8
								6
							5
				3		4
			2
	1

2H258-17R RESET

PWR CPU

COM

RESET Button 3068-10

To reset the 2H258-17R processor, press and release the RESET button. The 2H258-17R goes through a reset process for approximately 60 seconds. Additional downtime may result as the device reenters the network.

NOTE: It is not recommended to press the RESET button while the device is already in reset mode. If so, the device will enter an extended diagnostic procedure, which is unnecessary for normal operation. This extended diagnostic procedure takes much longer than a minute.

4-8Troubleshooting