Connecting to the Network

Figure 3-5 2H258-17R Rear View

Redundant

Primary

AC outlets are

 

on separate circuits

26001-06

2.Observe the LANVIEW LEDs. After a successful boot, the PWR LED turns ON (green). If the PWR LED is amber, there is no power redundancy. Check the power cord connections and the power source. If there are no problems with the power cord connections or power source and the PWR LED is still amber, contact Enterasys Networks. Refer to Section 1.2 for details.

3.4CONNECTING TO THE NETWORK

This section provides the procedures for connecting fiber optic segments from the network or other devices to the 2H258-17R.

NOTE: If the 2H258-17R is being installed in a network using SmartTrunking, there are rules concerning the network cable and port configurations that must be followed for SmartTrunking to operate properly. Before connecting the cables, refer to the SmartTrunk User’s Guide for the configuration information.

Ports 1 through 16 on the 2H258-17R have MT-RJ connectors for multimode fiber optic cable connections.

3-8Installation

Page 34
Image 34
Enterasys Networks 2200 manual Connecting to the Network, Redundant Primary AC outlets are On separate circuits