Enterasys Networks 2200

Removing the Chassis Cover

B-4 Optional Installations and Mode Switch Bank Settings

Figure B-1 Removing the Chassis Cover

2504-30

Note: If the device was rack mounted, the four screws fastening the cover to

the front panel are removed and installed along with the rackmount brackets.

Chassis

Front Panel

Screws (4)

Chassis Cover

Contents

Main Page NOTICE FCC NOTICE ELECTRICAL HAZARD: Only qualified personnel should perform installation procedures. Page ENTERASYS NETWORKS, INC. PROGRAM LICENSE AGREEMENT Page Page DECLARATION OF CONFORMITY Contents ABOUT THIS GUIDE 1 2 3 4 INDEX A B Figures Page About This Guide USING THIS GUIDE STRUCTURE OF THIS GUIDE Important Notice RELATED DOCUMENTS Management Users Guide DOCUMENT CONVENTIONS Page Introduction 1.1 OVERVIEW Important Notice 1.1.1 Connectivity 1.1.2 Runtime IP Address Discovery 1.1.3 Full Duplex Switched Ethernet 1.1.4 SmartTrunk 1.1.5 Remote Monitoring (RMON) 1.1.6 Broadcast Suppression 1.1.7 Port/VLAN Redirect Functions 1.1.8 Traffic Rate Limiting 1.1.9 Flow Control 1.1.10 GARP Switch Operation 1.1.11 802.1 Port Priority 1.1.12 Management 1.1.13 Switching Options 1.1.14 Optional HSIMs and VHSIMs 1.1.15 Standards Compatibility 1.1.16 Year 2000 Compliant 1.1.17 LANVIEW Diagnostic LEDs 1.2 GETTING HELP Page Network Requirements 2.1 SmartTrunk 2.2 100BASE-FX NETWORK Page Installation 3.1 UNPACKING THE DEVICE 3.2 INSTALLING OPTIONS 3.3 INSTALLING THE DEVICE 3.3.1 Tabletop or Shelf Installation 3.3.2 Rackmount Installation Strain-Relief Bracket Strain-Relief Bracket Screws Rackmount Bracket Rackmount Bracket Screws 3.3.3 Connecting Power 3.4 CONNECTING TO THE NETWORK Page Page 3.5 COMPLETING THE INSTALLATION Page Troubleshooting 4.1 USING LANVIEW Page Page 4.2 TROUBLESHOOTING CHECKLIST Page Page Page 4.3 USING THE RESET BUTTON The RESET button shown in Figure4-2 resets and re-initializes the 2H258-17R. A Specifications A.2 PHYSICAL PROPERTIES A.1 DEVICE SPECIFICATIONS Page A.6 COM PORT PINOUT ASSIGNMENTS A.7 REGULATORY COMPLIANCE Page B Optional Installations and Mode Switch Bank Settings B.2 REMOVING THE CHASSIS COVER This section describes how to remove the 2H258-17R chassis cover. Page Page B.3 SETTING THE MODE SWITCHES Page B.4 SIMM UPGRADE B.4.1 Locating SIMMs B.4.2 Installing the DRAM SIMM B.5 INSTALLING OPTIONAL HSIM OR VHSIM INTERFACE MODULES Optional HSIM or VHSIM Connectors Page Index M N P R S