Required Tools | Enterasys Networks 2200 instruction

B

Optional Installations and

Mode Switch Bank Settings

ELECTRICAL HAZARD: ONLY QUALIFIED SERVICE PERSONNEL SHOULD ATTEMPT THE FOLLOWING PROCEDURES.

NUR QUALIFIEZIERTE SERVICE PERSONNAL DIE FOLGENDE PROCEDURE FOLGEN SOLLTEN.

SOLAMENTE PERSONAL CALIFICADO DEBE INTENTAR ESTE PROCEDIMIENTO.

The top cover must be removed to gain access to the mode bank switches, to install optional FLASH or DRAM Single In-line Memory Modules (SIMMs), or to install an optional High Speed Interface Module (HSIM) or Very High Speed Interface Module (VHSIM).

This appendix covers the following items:

•Required tools (Section B.1)

•Removing the chassis cover (Section B.2)

•Locations, functions, and settings for the mode switches (Section B.3)

•Installing optional SIMM upgrades (Section B.4)

•Location of Optional HSIMs (Section B.5)

B.1 REQUIRED TOOLS

Use the following tools to perform the procedures provided in this appendix:

•Antistatic wrist strap

•Phillips screwdriver

Optional Installations and Mode Switch Bank Settings B-1

Image 51

Enterasys Networks 2200 manual Optional Installations Mode Switch Bank Settings, Required Tools

Contents

2H258-17R SmartSwitch Installation User’s Guide Page FCC Notice Industry Canada Notice Vcci NoticeClass a ITE Notice Bsmi EMC Statement Taiwan You and Enterasys agree as follows Enterasys NETWORKS, INC Program License AgreementPage Page Declaration of Conformity Contents Troubleshooting Figures Tables Using this Guide About This GuideStructure of this Guide Related Documents This guide uses the following conventions Document ConventionsPage Overview Introduction Runtime IP Address Discovery Connectivity Full Duplex Switched Ethernet SmartTrunkRemote Monitoring Rmon Broadcast Suppression Port/VLAN Redirect FunctionsTraffic Rate Limiting Garp Switch Operation Flow Control11 802.1 Port Priority Standards Compatibility Switching OptionsManagement Optional HSIMs and VHSIMs Getting Help Lanview Diagnostic LEDsPage 100BASE-FX Network Network RequirementsPage Installation Unpacking the Device Installing Options Tabletop or Shelf Installation Installing the Device Guidelines for the Rackmount Installation Rackmount Installation Strain-Relief Bracket Screws Rack Mounting the 2H258-17R Installing the Device in a Rack Connecting Power Redundant Primary AC outlets are On separate circuits Connecting to the Network Connecting to the Network Fiber Optic Connection Completing the Installation Page Using Lanview Troubleshooting PWR CPU OFF Troubleshooting Checklist Refer to the SmartSwitch Series 2E253 2E253, 2H252, 2H253, and 2H258 Local User parameters Reset Button Using the Reset Button Specifications Device SpecificationsPhysical Properties Electrical Specifications Environmental RequirementsINPUT/OUTPUT Ports Regulatory Compliance COM Port Pinout AssignmentsPage Required Tools Optional Installations Mode Switch Bank Settings Removing the Chassis Cover Optional Installations and Mode Switch Bank Settings B-3 Figure B-1 Removing the Chassis Cover Figure B-2 Mode Switch Location Setting the Mode Switches 6Optional Installations and Mode Switch Bank Settings Locating SIMMs Simm Upgrade Installing the Dram Simm Figure B-5 Hsim and Vhsim Connector Locations Installing Optional Hsim or Vhsim Interface ModulesPage Numerics Index Index-2