Installing the Device
Installation
Rack mounting the 2H258-17R involves the following:
•Attaching the strain-relief bracket
•Rack mounting the 2H258-17R (attaching the mounting brackets and fastening the device to the rack)
Attaching the Strain-Relief Bracket
Attach the strain-relief bracket to the 2H258-17R as follows:
1.Locate the strain-relief bracket and four 8-32 x 5/16-inch pan-headscrews in the rackmount kit.
CAUTION: Do not attempt to attach the strain-relief bracket with screws other than the 8-32 x 5/16-inch screws included with the 2H258-17R. Use of longer screws may damage the unit.
2.Place the 2H258-17R upside down (as shown in Figure 3-2) on a clean flat surface. Then attach the strain-relief bracket to the bottom of the 2H258-17R using the four 8-32 x 5/16-inch pan-head screws.
Figure 3-2 Attaching the Strain-Relief Bracket
Strain-Relief
Bracket Screws
Strain-Relief
Bracket
| | | | | | | | | | | | | CPU | COM | RESET | 17R-2H258 |
| | | | | | | | | | | | | |
| | | | | | | | | | | | | PWR | | | |
16 | 15 | 14 | 13 | 12 | 11 | 10 | 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 | |
TX RX | TX RX | TX RX | TX RX | TX | RX TX RX | TX RX | TX RX | TX RX | TX RX | TX RX | TX RX | TX RX TX RX | TX RX | TX RX | |
| | | | | | | | | | | | | SWITCH WORKGROUP ETHERNET FAST |
3068-03
