Overview
The RAD requests start at an interval of 1 per second. The interval then doubles after every transmission until an interval of 300 seconds is reached. At this point, the interval remains at 300 seconds. The RAD requests continue until an IP address is received from a RARP or BootP server, or an IP address is entered using Local Management.
NOTE: The
1.1.3Full Duplex Switched Ethernet
Each switched Fast Ethernet port on the
200 Mbps of bandwidth to connected devices that support FDSE.
1.1.4SmartTrunk
Traditional 802.1D Spanning Tree Bridges only allow one active data path between any two switches; all other parallel data paths are in Standby or Blocking mode. If one interface or path should fail, then the other interface automatically comes out of Blocking mode and forwards all of the traffic. This is fine for redundancy purposes. However, it is not the most efficient use of resources.
SmartTrunk, also referred to as SmartTrunking, is Enterasys Networks’ terminology for load balancing or load sharing. SmartTrunk provides the ability to take full advantage of the network’s redundant bandwidth. SmartTrunk divides network traffic across multiple ports in parallel to provide additional throughput. The SmartTrunk application can be used with any of Enterasys Networks’ switch modules (except ATM modules).
For more information about SmartTrunk and how to configure it the SmartSwitch device, refer to the Enterasys Networks SmartTrunk User’s Guide.
1.1.5Remote Monitoring (RMON)
The
Enterasys Networks RMON Actions is a
Introduction
