Enterasys Networks manual Using Lanview, Lanview LEDs of A2H123-24

Using LANVIEW

Using LANVIEW

These switches support the Enterasys Networks built‐in LANVIEW LED visual diagnostic and status monitoring system. The LANVIEW LEDs on the A2H123‐24 are shown in Figure 4‐1. These LEDs allow you to quickly observe network status for diagnosing switch and network problems.

Figure 4-1 LANVIEW LEDs of A2H123-24

1	Recessed password reset button	5	10/100 Mbps ports Link/Activity LEDs
2	Redundant power supply active	6	1000 Mbps stacking ports Link/Activity LEDs
3	Unit selected as stack manager	7	LC connector ports Link/Activity LEDs

4CPU and power indicator

Note: The terms flashing, blinking, and solid used in Table 4-1indicate the following:

Flashing: LED is flashing randomly.

Blinking: LED is flashing at a steady rate (approximately 50% on, 50% off).

Solid: LED is on steady and not pulsing.

4-2 Troubleshooting