Enterasys Networks A2H123-24 manual C2RPS-SYS Redundant Power System

Connecting AC and RPS-SYS Power

C2RPS-SYS Redundant Power System

If you are installing an optional redundant power system (C2RPS‐SYS), refer to the installation instructions supplied with the SecureStack RPS. The switch is connected to a C2RPS‐PSM using a C2RPS‐PSM Cable.

Figure 3-7 Accessing the RPS Connector

1 RPS coverplate 3 Screw holes for coverplate

2Retaining screws to fasten plate

Caution: To prevent damaging the switch, DO NOT connect a Power over Ethernet-compliant Redundant Power System (C2RPS-POE) to the redundant power supply connector. The switch is only compatible with the SecureStack C2RPS-SYS redundant power supply system.

Precaución: No conecte una fuente de poder redundante (RPS) SecureStack PoE (C2RPS-POE) al cable de corriente. De lo contrario, el dispositivo puede dañarse.

If you are installing the switch as a standalone switch, proceed to “Connecting to Console Port for Local Management” on page 3‐15. If you are installing switches in a stack configuration, apply power to each switch in order, according to the procedure described in “Configuring Switches in a Stack” on page 3‐9.

3-14 Hardware Installation