Envision Peripherals NV3128 manual Operation from a Floppy Disk, Hardware Configuration

OPERATION FROM A FLOPPY DISK

A. Copy the program files supplied to a blank floppy.

B. Invoke either program from the floppy. Edited map, config and salvo files will be saved to the floppy in the course of the program session.

C. Remove the floppy and store it safely.

HARDWARE CONFIGURATION

A.Refer to "Configuring the Diagnostic Interface" earlier in this section to configure the diagnostic interface for RS-232 operation. Additionally, configure the serial controller data port for RS-232 operation if the use of NVTake is anticipated.

B.Connect the RS-232 cable to the computer serial port, COM1 or COM2, and to the appropriate connector on the router Control Interface.

·NVMap communicates with the diagnostic data port J400, located on the front of the Command Interface Module.

·NVTake communicates with the RS422/RS232 Command Data Port at the rear of the frame.

NV3128 RS-422A Machine-Control Routing Switch 2-24