8.Connect the AC line cord at the rear of the frame and to the input AC, which powers up the NV3128. Ensure the system powers up correctly.
a.LEDs on the Power Supply front panel should glow.
b.Measure the voltages at the DC tespoints on the Power Supply. The value should be within +/- 1VDC of the value silkscreened at the test point. (If no boards are plugged in, the voltages will be very high, around ±9 and ±20 volts.)
9.Disconnect the AC line cord(s) from the PS2001 power supply(ies). Secure the Power Supplies with the front panel captive latch screws.
10.Cable the system as explained later in this chapter.
11.Set jumpers on the Command Interpreter (older systems only) as discussed later in this chapter.
12.Engage all active circuit modules. Ensure they are plugged into their correct slots as silkscreened on the frame and front panels.
13.
a.LEDs on the active modules should glow, indicating power is on.
b.As an extra precaution, measure the voltages at the DC test points on each active module in the frame. The value should be within
NV3128 |
