4.2.5UNIVERSAL CONTROL/COMMAND INTERPRETER MODULE ASSY:
The following discussion refers to both the Universal Control and Command Interpreter modules. Although these modules use different designs, they are functionally very similar.
The Universal Control/Command Interpreter Module receives take commands from an external controller and reformats them for use by the Crosspoint Module. Additionally, the module parses the incoming commands to determine which port of a connection is controlled, and which is controlling. It subsequently sends control data to the I/O boards to select the state of the ports accordingly.
Further, the assembly contains all circuitry required to configure the
NV3128, and produces master timing signals for the system.
MAPPING
At the heart of the module are the microprocessors that govern circuit operation. The firmware configuring these devices , stored in EPROMs, is especially tailored to the controller protocol the module is to interpret. This approach lends itself to custom control interfaces and simplifies the development of new ones.
The microprocessors process matrix data stored in SRAM into address and control data for use by the crosspoint and I/O modules. The SRAM IC is divided into two memory banks, A and B. Only one of these banks is active at any time.
Line driver/receivers link a UART with the external controller . A microprocessor writes the UART data into the inactive RAM bank. Once the data is read, the banks reverse roles: the newly written RAM defines the matrix, while the other becomes inactive, and thus, writeable. The use of dual memories allows data to be entered at any time without disturbing the gate array’s bitstream generation. Line drivers drive output address and control data over the signal backplane to the crosspoint and I/O modules.
Matrix information is also stored in a third memory. If system power is lost, the charge on a
NV3128 |
