Cut-Sheet Feeders

5.Insert up to 50 sheets of paper along the left paper guide.

6.Adjust the position of the right paper guide so that it matches your paper’s width. Make sure the position of the guide allows the paper to move up and down freely.

7.Push the paper-set levers back to clamp the paper against the guide rollers.

8.If necessary, attach the stacker-support wires (that come with the cut-sheet feeder) to the edge guides of the paper guide.

9.Replace the paper guide by placing the notches on the paper guide straight down over the mounting posts on the printer. Lower the paper guide into position and then slide the edge guides to the middle.

Note: When the cut-sheet feeder is installed, you can still load single sheets using the top paper guide or the front paper slot.

The cut-sheet feeder automatically data to the printer (as long as the also load paper from the cut-sheet LOAD/EJECT button.

loads paper when you send print PAUSE light is not on). You can

feeder by pressing the

Using Printer Options 4-5