Printing with EPSON Stylus RIP for Macintosh

Setting Up the EPSON Stylus RIP Server

Follow the steps below to set up the EPSON Stylus RIP Server software the first time you use it—you’ll need to do this for both standalone and network configurations.

1.Make sure the Stylus RIP Server application has at least 20MB of RAM available. Open the Stylus RIP folder on your hard disk and highlight the StylusRIP Server icon. Choose Get Info from the File menu, then set the following Memory Requirements:

◗Preferred Size 20000K

◗Minimum Size 16000K

Note:

If you are not running your Macintosh with virtual memory turned on, increase each of the Memory Requirements by 4000K.

2.Disable all desktop printing extensions.

3.Turn on the printer and wait to make sure its power light comes on and the light is not flashing. Make sure the printer is properly connected to your Macintosh or network.

4.Start the Stylus RIP Server application by double-clicking the StylusRIP Server icon.

5.The first time you run the server software, a dialog box asks you to select your port or your printer name. Select the appropriate modem, printer, or USB port if you are connected to the printer via a serial, USB, or EPSON USB Adapter cable.

2-2