Epson 8150i Configuring the Projector to the Network, Determining How Your Network is Set Up, Simple peer-to-peernetwork, Example:, ■the subnet mask

Configuring the Projector to the Network

Make sure the projector is connected to your local area network (LAN) and equipped with a memory card, as described in Chapter 1. Then follow the steps below to configure your projector with the correct TCP/IP address and other network parameters.

Determining How Your Network is Set Up

The way you configure your projector depends on how your existing network is set up. Note any required parameters, as described below, depending on the type of network you have in place.

Simple peer-to-peer network

You have a simple peer-to-peer network if it your equipment is connected through a hub, as shown below:

Hub

Projector name : EasyMP.net
IP Address : 192. 168. 1. 1
Subnet Mask : 255. 255. 255.0	Computer name : PC5
		Computer name : PC10
	IP Address : 192. 168. 1.5
		IP Address : 192. 168. 1. 10
	Subnet Mask : 255. 255. 255.0
		Subnet Mask : 255. 255. 255.0

Before configuring the projector, note the following information:

■the first three octets of the IP addresses on the network (the first three octets are the same for all devices):

Example: 192.168.1.10

first three octets

■the subnet mask

46Setting up EasyMP.net